| VCS Deployment Methods | 41
2.
Configure and save the following setting:
Parameter Description Configuration Method
Remote Control Enabled
Disable the remote control.
Note: the default value is On.
If you select Off, you cannot use
the real remote control or the
virtual remote control to control
the system.
Web user interface
Using CTP20 Touch Panel
You can use CTP20 Touch Panel to configure and control VC880/VC800/VC500/VC200. For more information about
how to use CTP20 Touch Panel, refer to Yealink CTP20 Quick Start Guide.
Using CP960 Conference Phone
You can use the CP960 conference phone to perform calling and partial configuration tasks. For more information
about how to use CP960 conference phone, refer to Yealink CP960 HD IP Conference Phone Quick Reference Guide.
VCS Deployment Methods
This chapter introduces how to deploy VCS.
•
Traditional Deployment Methods
•
Cloud Deployment Method
Traditional Deployment Methods
If you do not use cloud-based service, you can choose the traditional deployment method to deploy your VCS.
•
Public IP Configuration
•
Port Forwarding
•
NAT
•
STUN
•
H.460
•
Intelligent Traversal
•
VPN
Public IP Configuration
For a higher demand of the audio and video, you can connect your video conferencing system to the Internet directly.
To Next Page
Loading...
