Yealink VS800 - Page 54

| Configuring Network Settings | 54
Parameter Description Configuration Method
DHCP
Enable or disable the system to
obtain network settings from the
DHCP server.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Static IP
Enable or disable the system
to use manually configured
network settings.
Note: the default value is Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
IP address
Configure the IPv4 address
assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Subnet Mask
Configure the subnet mask
assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Gateway Configure the gateway assigned
to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Static DNS
Enable or disable DNS feature.
Note: the default value is Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Primary DNS/DNS primary
Server
Configure the primary DNS
server assigned to the system.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20