| Configuring Network Settings | 66
Adding Connected Devices to the Blacklist
You can add connected devices to the blacklist, and the device is disconnected from the wireless AP.
Procedure
1.
Do one of the following:
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP > AP Device
List.
On your VC200, go to More > Network > Wireless AP > AP device list.
On your VP59, tap Setting > Network & Connection > Wireless AP > AP device list.
• On your CTP20, tap Setting > Advanced > Wired Network > Wireless AP > AP Device List.
2.
Select the desired device.
The monitor prompts “Move the device into blacklist?”.
3.
Confirm the action.
The device is disconnected from your system, and cannot be connected to the wireless AP provided by your
system any more.
Removing Devices from the Blacklist
You can remove devices from the blacklist, so that the devices can connect to the wireless AP provided by your
system.
Procedure
1.
Do one of the following:
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP > Blacklist.
On your VC200, go to More > Network > Wireless AP > Blacklist.
On your VP59, tap Setting > Network & Connection > Wireless AP > Blacklist.
• On your CTP20, tap Setting > Advanced > Wired Network > Wireless AP > Blacklist.
2.
Select the desired device.
The monitor prompts “Remove the device from blacklist?”.
3.
Confirm the action.
After removed from the blacklist, the device can search and connect to the wireless AP provided by your system.
Disabling the Wireless Access Point
Procedure
1.
Do one of the following:
• On your web user interface, go to Network > Wireless AP.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP.
On your VC200, go to More > Network > Wireless AP.
On your VP59, tap Setting > Network & Connection > Wireless AP.
• On your CTP20, tap Setting > Advanced > Wired Network > Wireless AP.
To Next Page
Loading...
