| Configuring Network Settings | 71
Data QoS
To ensure better presentation, data packets (PC content) emanated from the system should be configured with a high
transmission priority. DSCPs for audio, video and data packets can be specified respectively.
•
Configuring QoS
Configuring QoS
Procedure
1.
Do one of the following:
• On your web user interface, go to Network > Advanced > QoS.
• On your VCS:
For VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Advanced Network >
QoS.
On your VC200, go to More > Network > Wired Network > Advanced Network > QoS.
On your VP59, tap Setting > Advanced > Advanced Network > QoS.
• On your CTP20, tap Setting > Advanced > Advanced Network > QoS.
2.
Configure and save the following settings:
Parameter Description Configuration Method
QoS
Enable or disable the QoS
feature.
Note: the default value is Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Audio Priority
Configure the DSCP
(Differentiated Services Code
Point) for audio packets.
Note: the default value is 63.
The greater the number is, the
higher the priority is. If you
change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Video Priority Configure the DSCP
(Differentiated Services Code
Point) for video packets.
Note: the default value is 34.
The greater the number is, the
higher the priority is. If you
change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
