Yealink VS800 - Page 89

| Configuring Account Settings | 89
Parameter Description Configuration Method
Password
Specify the password for this
Pexip account.
Default: blank.
Web user interface
Endpoint
CTP20
Server Host/Server
The IP address or domain name
of the Pexip server.
Default: blank.
Web user interface
Endpoint
CTP20
Port
The port of the Pexip server.
Default: 0.
Web user interface
Endpoint
CTP20
Remember password
Enable or disable remembering
password.
Note: the default value is Off.
If it is set to On, the password
will be filled in automatically
when you enter the username
next time.
Endpoint
CTP20
Transport
Configure the transport protocol
for transmitting the SIP
signaling.
The supported protocols are as
follows:
• UDP—it provides the
best transmission for SIP
signaling.
• TCP—it provides a reliable
transmission for SIP
signaling.
• TLS—it provides a safe
transmission for SIP
signaling. TLS is available
only when the device is
registered on a SIP server
that supports TLS.
• DNS-NAPTR—the device
performs the DNS NAPTR
and SRV request to find the
service type and the port if
no server port is given.
Default: TCP.
Web user interface