Yealink VS800 - Registering an Easymeet Account

| Configuring Account Settings | 91
Parameter Description Configuration Method
Server Host/Server
The IP address or the domain
name of the BlueJeans server.
Default: bjn.vc.
Web user interface
Endpoint
CTP20
Transport
Specify the transport protocol
for transmitting the SIP
signaling.
The supported protocols are as
follows:
• UDP—it provides the
best transmission for SIP
signaling.
• TCP—it provides a reliable
transmission for SIP
signaling.
• TLS—it provides a safe
transmission for SIP
signaling. TLS is available
only when the device is
registered on a SIP server
that supports TLS.
• DNS-NAPTR—the device
performs the DNS NAPTR
and SRV request to find the
service type and the port if
no server port is given.
Default: TCP.
Web user interface
Server Expires
The registration timeout (in
seconds) of the device.
After the timeout, the device will
send the registration request to
the server again.
Default: 3600.
Web user interface
Keep Alive Interval
Configure the interval (in
seconds) that the device sends
keep-alive messages to the SIP
server, so that the SIP server can
remain connected to the device.
Default: 30.
Web user interface
Registering an EasyMeet Account
You can register the EasyMeet account and do the following:
When you place a call using the EasyMeet account, you can:
• Dial the EasyMeet account to establish a point to point call.