Yealink W75 Mini MC - Page 4

• Deploy two or three W75 Mini MC
Deploying the Device
1. Connect all W75 Mini MC to a POE or network
cable + power supply to make the W75 Mini MC
start normally. Please refer to
Deploy one W75
Mini MC
to connect the DM to the Base. The LED
indicator status are as follows:
2. Select a W75 Mini MC as the primary
DM and the primary Base (Figure
"A"
)
.
Remember the MAC address of the
primary base, so that you can quickly nd
the primary base later.
3. Press and hold the Base button of the
rest of W75 Mini MC (Figure
"B/C"
) for 10s
to enter the DM role switching. The LED
indicator status are as follows:
Ⓐ Ⓑ Ⓒ
C
C - 1 C - 2
B
B B
4. Press the Base button (Figure
"B/C"
). At this time, the LED indicator status are as
shown in Figure
"B/C - 1"
.
After 3s, the DM reboots and switches to secondary DM and the LED indicator status are
as shown in Figure
"B/C - 2"
.
Then disconnect the W75 Mini MC (Figure
"B/C"
) from a POE or network cable + power
supply.
LAN LED: green
LAN LED: green
LAN LED: green LAN LED: green
ROLE LED: ash orange
ROLE LED: orange
ROLE LED: green ROLE LED: green
DECT LED: green
DECT LED: green
DECT LED: green DECT LED: off