Yedoo S2020 20"/20" User Manual

14
8.a
Installing the rear wheel (V-brake)
Release the brake cable from the guide
(
1
), Put the wheel in one of the two fork
dropouts (see 8.b, 8.c.) then centre the
wheel and tighten the quick release
mechanism (
2
).
1
2
9.
8.b 8.c
Installing the brake cables
Squeeze the brake lever to the maximum
and insert the end of the brake cable
into the round lug (
1
). Insert the cable
into the groove and tighten the set
screw (
2
) and the nut (
3
). Repeat the
process with the other brake.
The rear brake cable is usually mounted
on the right brake lever and the front
brake wire on the left.
Use the lower position for riding over
rough terrain. Close the quick release
lever. It should point upwards.
Two-position rear fork enables you to
adjust the height of the footrest above
the ground. The upper fork position,
which reduces the height of the footrest,
is designed for riding on a smooth, flat
surface. Riding will be less physically
demanding. The closed quick release
lever should point downwards.
1
2
3
Rear wheel installation (disc brake)
Put the wheel in the fork dropout, centre
the wheel and fasten the quick-release
lever.
8.e
8.d
1
2
19–20 Nm
Three
Release the brake cable from the guide
(
1
)
, Put the wheel in one of the two fork
dropouts (see 8.b, 8.c.) then centre the
wheel and tighten both nuts (
2
).
Installation manual
EN

Yedoo S2020 20"/20" Specifications

General

Brand	Yedoo
Model	S2020 20"/20"
Category	Scooter
Language	English