Yepp solo - Install Safety Flag; Adjust Push Handle; Brake Operation; Install Bicycle Coupler

GMG050  version03-2015


 
Theagismadeupof2parts.Insertbothpartsintoeachotherand
placetheaginthecoveronthesideofthetrailer.usethe
bicycleagwhenusingthetrailerasabicycletrailertoensuregood
visibilityintrafc.
 
IfyouusetheYepptrailerasabuggy,youcanadjustthepositionofthe
pushhandlebasedonyourpersonalpreferenceandlength.
Unlockthetwoclampsontheleftandrightandmovethe
handletowardsyou.Ifrequired,loosentheclampsafewturns.
Oncethecorrectadjustmenthasbeenachieved,youcanagainxthe
handlebytighteningbothclamps.Iftheydonotclampenough,youcan
tightentheclampsafewturnsbeforeyouxtheclamps.Whenused
asatrailer,werecommendfoldingthepushhandlefullytothefront
andtoagainsecureitusingtheclamps.
 
1 Pulltheroundblackbuttonto;
thetrailerwillbeonthebrakeinthisposition.
2 Pushtheroundblackbuttonto;
thetrailer'sbrakewillbedisengagedinthisposition.
Alwayscheckwhetherthebrakehasreallybeenengaged.
 
Firstthecouplermustbeinstalledontherearshaftofthebicycle
beforeyoucanusethetrailerasabicycletrailer.Inprinciple,thisis
theleftside(whenviewedfromthecyclingdirection)ofthebicycle.
Usethesidethatdoesnothavethebicyclechaininstalled.
Loosenthenutoftherearshaftofthebicycleandpositionthetrailer
couplerontheshaft.Next,againpositionthenutontheshaftand
tightenitusingthetorquerecommendedbythebicyclemanufacturer.
Werecommendhavingarecognisedprofessionalcarryoutthis
installationforreasonsofsafety.
 
Checkthateverythinghasbeeninstalledcorrectlybeforeyouconnect
thetrailertothebicycle.Placethebicycleonarobustatsurfaceand
useatwo-leggedkickstandforthebicycle.
• Slidethecoupleronthefrontsideofthedrawbaroverthebicycle
coupler.
• Insertthelockingpinthroughthebicyclecouplerandthe
drawbarandpullthelockingspringaroundtheprotrudingpart
ofthelockingpin.
• Checkthatthecouplerissufcientlyxedbypullingthedrawbar.
Alwaysensurethatthebicyclecannottoppleover.
• usetheadditionalsafetybandbypullingitthrough
attherearoftheframeandsecuringthehooktotheD-ringon
thedrawbar.
Carefullycheckwhetherthesafetybeltcannotcomein-between
themovingpartsofthebicycle.Ifrequired,winditaroundtheframe
severaltimes.
• Alwaysusetheagwhilecyclingforextrasafety.
• Theparkingbrakemustalwaysbedisengagedwhencycling.
EN