7
F.F. Acquisition Corp. YERF-DOG Warranty Dept.
1743 South Horne # 100
Mesa, AZ 85204
FOR REPLACEMENT PARTS PLEASE CALL:
1-888-926-6554 (U.S.) 1-888-707-1880 (Canada)
ASSEMBLY
1. Complete the Fun-Kart registration and warranty confirmation on the back of this owners manual
and mail in within 10 days of purchase. The information is required when ordering parts.
2. Steering Wheel - Bolt the steering wheel to the anchor plate with fasteners provided in the parts
bag provided with the Fun-Kart. See Steering Wheel Assembly Instructions page 11.
3. Brush Guard - Bolt the Brush Guard to frame with bolts provided in the parts bag. See Brush
Guard and Foam Assembly Instructions page 12.
4. Foam - Attach Foam to Brush Guard. See Brush Guard and Foam Assembly Instructions
page 12.
5. Bolts - Check the screws, nuts and bolts on your vehicle to see that all are tightened securely. For
safe operating conditions, do periodic checks and tighten securely.
6. Engine - Fill the crankcase with oil until it reaches the FULL mark on the dip stick. DO
NOT
fill above the FULL mark. Approximately 20 oz. or 1¼ pints (.6 Liters) of SAE 30 weight oil.
For additional information refer to Tecumseh engine manual for servicing the engine.
7. Fill fuel tank with regular gasoline, leaded or unleaded. Do not use premium gasoline. Do not
overfill (No fuel in filler neck).
8. Tire Pressure
CHECK AIR PRESSURE IN TIRES!!
It is common industry practice to overinflate the tires. This is done to guarantee an airtight seal. Prior
to riding the Fun-Kart for the first time, you may need to reduce the air pressure in the tires to the
specifications stated below:
Rear Tires 20 PSI
Front Tires 24 PSI
Proper tire pressures will increase the life of the tire and enhance the performance of the Fun-Kart.
Driving on asphalt or concrete
will significantly reduce the life of the tire!!
To Next Page
Loading...
Need help?
General