7 / 8
location management： introduced to "add new location, edit location, change of device location, or
delete"
ό
Device control：introduce you to the application of "Device details control"
ό
Note: Will introduce you to the use of APP
4.3.4 One key to net in
Ψ
When the APP was installed,will introduce you to add a controller
ό
Click -> (before entering the password,please press adding device confirm after entering the password
of WIFI module button or controller UP button until seeing quick flashing)->three times completed
ό
For more detailed instructions can be seen in the APP user manual
8 / 8
4.3.5 The main control page of the product
Ψ
When you successfully add the new device, pls click on the new device added, in which will enter the
following main control page of the product.At this time, you can enjoy the fun and convenience intelligent.
.
5
FAQ
Q1: Add device failed, and the LED indicator was slow flashing all the time
The LED indicator slow flashing means that it is connecting the router, the connection time over 60S,
it is fail, for that case, maybe wrong with "password entered error" or "data error in transmission". The
user need check the status of the cell phone or router network,and ensure router wife without any limit
contact,please try again for new reconfiguration.
Q2: The device is suddenly out of control
Check the router WIFI, whether the password is changed or not, and check the status of the red
indicator on the device, if it's slow flashing, this is disconnected from the router and controller， you need
reconfigure it.
Router assigns to the IP address of device because of the network, the IP address is changed, it
causes the actual IP of device to be inconsistent with the APP saved equipment, at this moment exit the
APP and restart, and retrieve the device information.
To Previous Page
Loading...