Frameset User Manual
Over-tightening hardware could deform or break the hardware or
components. Under-tightening hardware could cause hardware
or components to become loose. Either situation could damage
the bicycle and result in injury to the rider.
All reused-fasteners with pre-applied threadlocker must be
cleaned with isopropyl alcohol and have new thread locker
applied before re-assembly. If threadlocker is not applied, the
fasteners may loosen which could damage the bicycle and result
in injury to the rider.
Properly tighten hardware
Reapply threadlocker
always tighten hardware to the specied torque.
Apply appropriate grease
Apply threadlocker
Torque
Cable (zip) tie
Nm
Safety Legend
WARNING
WARNING
To Next Page
Loading...