YOKOGAWA 436106 - Page 66

4-23
IM 04P01B01-17E
Commands
4
• On models with the computation function (/M1
option), computation channels can be
specified.
UB Sets the display mode of the bar
graph.
Syntax UB p1,p2<terminator>
p1 Channel number
p2 Bar graph display mode
NORMAL The reference position is set
to the smaller of the two
values, leftmost value and
rightmost value.
CENTER The reference position is set
to the 50% position.
Query UB[ p1]?
Example Display channel 01 using a bar graph with the
reference position set to the 50% position.
UB 01,CENTER
Description On models with the computation function (/M1
option), computation channels can be specified.
UI Sets whether to use moving
average (dot model).
Syntax UI p1<terminator>
p1 Use/Not use moving average (USE, NOT)
Query UI?
Example Use moving average.
UI USE
UJ Sets whether to use the input
filter (pen model).
Syntax UJ p1<terminator>
p1 Use/Not use the input filter (USE, NOT)
Query UJ?
Example Use the input filter.
UJ USE
UK Sets whether to use of partial
expanded recording.
Syntax UK p1<terminator>
p1 Use/Not use partial expanded recording
(USE, NOT)
Query UK?
Example Use partial expanded recording.
UK USE
UL Selects the display/printout
language.
Syntax UL p1<terminator>
p1 Language (ENGLISH, JAPANESE,
GERMAN, FRENCH)
Query UL?
Example Use English.
UL ENGLISH
XN Selects the date format.
Syntax XN p1<terminator>
p1 Date format for displaying and printing
Y/M/D: (example) 2005/08/31
M/D/Y: (example) 08/31/2005
D/M/Y: (example) 31/08/2005
D.M.Y: (example) 31.08.2005
M.D.Y: (example) Aug.31.2005
Query XN?
Example Set to the "2005/08/31" format.
XN Y/M/D
Description This setting applies to the format of the date
shown on the display and the date printed on the
periodic printout, manual printout, alarm printout,
message printout, recording start printout, new
chart speed printout, and start printout and end
printout (header printout (/BT1 option)).
Note
How this setting applies to the time printout format of the
alarm printout, message printout, recording start printout,
and new chart speed printout: The setting specifies the
format of the "M/D" and "Y/M/D" section when the time
printout format is set to "M/D H:M," "M/D H:M:S," or "Y/M/
D H:M:S."
XT Selects the temperature unit.
Syntax XT p1<terminator>
p1 Temperature unit
C °C
F °F
Query XT?
Example Use °F.
XT F
UF Sets whether to use the
extended functions.
Syntax UF p1,p2,p3,p4,p5<terminator>
p1 Bias function (USE, NOT)
p2 Square root low-cut function (USE, NOT)
p3 1-5V input low-cut function (USE, NOT)
p4 Alarm delay function (USE, NOT)
p5 Calibration correction function (USE, NOT)
(/CC1 option). This cannot be used with the
bias.
Query UF?
Example Use the calibration correction extended function.
The bias function is not used.
UF NOT,USE,USE,USE,USE
Description • The input offset is set using the VB command.
• The low-cut function is set using the SR
command.
• The delay alarm is set using the SA and BD
commands.
4.5 Basic Setting Commands