31
The elapsed time is displayed as follows:
0 sec. to 99 min. and 59 sec.: steps of 1 sec.
100 min. or more: steps of 1 min.
Press the HOLD key to stop recording. (The display shows the “ D•H ”
symbol.)
<To confirm the recording time>
For confirming the recording time, press the MIN/MAX key.
Subsequent pressing of this key repeats to display the present
minimum value (MIN), maximum value (MAX) and average value (AVG).
Press the HOLD key once again to restart recording.
Note
• No influence is exerted on the recorded data even if the test leads are
disconnected while the recording is stopped.
• If overload is recorded, the MIN or MAX display changes to “ OL ” display,
resulting in incorrect average data.
• For widely varying signal measurement, set the appropriate range in
which the MAX or MIN does not change to “ OL ” display.
● Memory Function
<To save a Data in internal memory>
The instrument can save a data using with the following two types of
modes.
SAVE-mode: Saves a data for one measurement
by manual operation.
LOGGING-mode: Automatically saves a data from
the start of logging.
Memory capacity
SAVE-mode: 50 data
LOGGING-mode: one time (600 data)
To Next Page
Loading...