Automatic Start at Specified Time on Specified Date
In this method, you set the integration start date and time via the setting
screen. For the setting procedure, see “Measurement Procedure” in Section
9.1, “Measuring Electric Energy,” and Section 7.2.8, “Setting Integration Start
Date and Time.”
● If Start Date and Time Are Set to Future Point of Time (Later than
Current Time)
Pressing the
key flashes the mark (on the screen) and LED
status indicator. The file number of the file to which the data is to be saved
is displayed for approximately two seconds (only if data saving to the PC
card is enabled [see Section 7.2.10]), then the file number display
disappears and appears, indicating that the power meter
has entered the integration standby state.
9.2 Starting and Stopping Integration
To Next Page
Loading...
