9-6
IM CW120-E
● If Start Date and Time Are Set to Past Point of Time (Earlier than
Current Time)
Pressing the key flashes the mark (on the screen) and LED
status indicator. The file number of the file to which the data is to be saved
is displayed for approximately two seconds (only if data saving to the PC
card is enabled [see Section 7.2.10]), then the file number display
disappears and appears, indicating that the power meter
has entered the integration standby state.
START
&STOP
LED status indicator:
Flashes during integration standby state
START&STOP key
Integration will begin at an appropriate time determined from the output
interval set.
mark flashes.
LED flashes.
mark lights.
LED lights.
End of
integration
Start of integration
(determined from output interval set)
Integration start
date and time set
LED status indicator
Integration standby
Integration in
progress
9.2 Starting and Stopping Integration
To Next Page
Loading...
