9-9
IM CW120-E
Electric Energy Measurement
9
9.2.3 Clearing Electric Energy Count
There are two ways to clear the electric energy count and elapsed time of
integration:
1. In the measurement mode, press the key for three seconds or more.
2. In the setting mode, choose the setting item for clearing the electric
energy count and resetting the system, and perform the specified setting
actions.
This section describes the former way. For the latter way, see Section 7.2.4,
“Clearing Electric Energy Count and Resetting System.”
Procedure
(1) When the measurement screen is displayed, press the (escape) key
for three seconds or more. Then, the mark appears and
flashes on the screen.
ENTER
ESC
RESET
ENTER key
ESC (escape) key
Electric Energy Count Clearance Screen
(2) Press the key. The electric energy count is cleared and the
measurement screen returns. To cancel, press the
key. The
measurement screen also returns.
9.2 Starting and Stopping Integration
To Next Page
Loading...
