9-16
IM CW120-E
● When a PC Card Having Sufficient Free Space Is Not Inserted during
Integration
Data is continuously saved to the backup memory. If integration ends
after the PC card has become full or when it is not inserted, you need to
carry out either of the procedures below.
If Data Is Needed
Follow the procedure below to copy the data from the backup memory to a
formatted, new PC card.
(1) Insert a new, formatted PC card.
(2) Press the
key to call the setting item selection screen.
(3) Using the
keys, select (make the mark appear).
(4) Press the
key. then flashes on the screen.
(5) Press the
key again. The data is then copied from the backup
memory to the PC card with the same file name. The
mark will
disappear, indicating that the copy has finished and data in the backup
memory has been cleared.
(6) Press the
key to return to the measurement screen.
Screen for Copying Data
SEE ALSO
Section 7.2.5, “Copying and Clearing Backup Memory Contents”
NOTE
If a file having the same file name resides in the PC card, the data is copied (added) to the bottom
of that file.
9.5 Backup Memory
To Next Page
Loading...
