YOKOGAWA CW120 - Page 117

9-17
IM CW120-E
Electric Energy Measurement
9
If Data Is Not Needed
Follow the procedure below to clear the data in the backup memory.
(1) Press the
key to call the setting item selection screen.
(2) Using the
keys, select (make the mark appear).
(3) Press the
key. then flashes on the screen.
(4) Using the
keys, change to .
(5) Press the
key. The data is then cleared from the backup memory.
(6) Press the
key to return to the measurement screen.
DISP
ENTER
MEAS/SET
MEAS/SET key
UP/DOWN/LEFT/RIGHT keys
ENTER key
Screen for Clearing Data
SEE ALSO
Section 7.2.5, “Copying and Clearing Backup Memory Contents”
NOTE
Starting the next integration will also clear the data in the backup memory.
9.5 Backup Memory