12-4
IM CW120-E
12.2 Using Optional Printer
● Checking Printer Settings
1. Keep pressing the Online switch of the printer and turn on the power.
Then, the printer settings are printed in English.
2. Check that the initial settings, as shown in parentheses inside the tables
below, are left.
Printer Initial Settings (DIP Switch Settings)
DIP SW-1
Setting Item ON OFF
1 (OFF) Input type Parallel Serial
2 (ON) Printing speed High Low
3 (ON) Auto-loading Enable Disable
4 (OFF) CR or CR/LF CR/LF CR
5 (ON) Setting command Enable Disable
6 (OFF)
7 (ON) Printing density = 100%
8 (ON)
DIP SW-2
Setting Item ON OFF
1 (OFF) Print mode 40 columns 80 columns
2 (ON)
Backup of user-defined characters
Enable Disable
3 (ON) Character type Normal Special
4 (ON) Character of zero 0 ∅
5 (ON)
6 (ON)
Encoding character set = Japanese
7 (ON)
8 (ON)
DIP SW-3
Setting Item ON OFF
1 (ON) Data bits 8 bits 7 bits
2 (ON) Parity (use/not use) Not use Use
3 (ON) Parity (even/odd) Odd Even
4 (OFF) Flow control H/W BUSY XON/XOFF
5 (OFF)
6 (ON)
Baud rate = 9600 bps
7 (ON)
8 (ON)
3. Turn off the power to the printer.
To Next Page
Loading...
