13-2
IM CW120-E
13.2 Error Codes
Error Code Description
Error in SRAM with battery backup
EEPROM has been initialized.
Checksum error of EEPROM
Illegal data in EEPROM
Failure in writing to EEPROM
RTC has been initialized.
Error in RTC
Error in PC card controller
Settings have been initialized.
Illegal settings
Failure in writing to PC card
Failure in reading from PC card
Maximum number files in PC card exceeded
A PC card other than a flash ATA card is inserted.
PC card not yet formatted
A PC card not supported is inserted.
Failure in deleting a measured-value file
Failure in saving the setting file
Failure in loading the setting file
PC card-related error other than above
Data in internal memory exceeds the capacity.
Failure in saving measured data within output interval
The electric energy value or elapsed time of integration is not zero. No
change to setting allowed.
The product of [rated power × VT ratio × CT ratio × 1.3] exceeds 9999 GW.
To return to the measurement screen from the error display, press any key.
To Next Page
Loading...
