YOKOGAWA CW120 - Memory Group; CARD Group

App 2-18
Appendix 2. Communication Commands
IM CW120-E
1.7.6 MEMOry Group
The MEMOry group contains commands
relating to acquisition of backup data in the
internal memory.
:MEMOry:DATA?
Function Queries the number of data backed
up in the internal memory.
Syntax :MEMOry:DATA?
:MEMOry:SEND?
Function Transfers the data backed up in the
internal memory.
Syntax :MEMOry:SEND?
:MEMOry:SEND?
→ STX (ASCII-code “02H”), file
contents, ETX (ASCII-code “03H”)
The STX and ETX are not attached
in RS-485 communication.
1.7.7 CARD Group
The CARD group contains commands relating
to the inserted PC card.
:CARD:DELEte?
Function Deletes the file that was specified
using the :CARD:FILEname and
:CARD:TYPE commands.
Syntax :CARD:DELEte?
:CARD:DIREctory?
Function Queries all the file names that have
been set using the :CARD:TYPE
command.
Syntax :CARD:DIREctory?
:CARD:FILEname
Function Sets/queries the names of all files
that reside in the PC card.
Syntax :CARD:FILEname?
:CARD:FILEname
{<Filename>}
<Measured data items> = Up to 8
characters
:CARD:FORMat
Function Formats the PC card.
Syntax :CARD:FORMat
:CARD:PICKout?
Function Queries all the settings relating to
transfer of a specified range of file
contents.
Syntax :CARD:PICKout?
:CARD:PICKout:END
Function Sets/queries the transfer end point.
Syntax :CARD:PICKout:END?
:CARD:PICKout:END {<NRf>}
<NRf> = 1 to 2147483647
:CARD:PICKout:SEND?
Function Transfers the contents (for the
range specified using the
:CARD:PICKout:STARt and
:CARD:PICKout:END commands)
of the file that was specified using
the :CARD:FILEname and
:CARD:TYPE commands.
Syntax :CARD:PICKout:SEND?
→ STX (ASCII-code “02H”), file
contents, ETX (ASCII-code “03H”)
The STX and ETX are not attached
in RS-485 communication.
:CARD:PICKout:STARt
Function Sets/queries the transfer start point.
Syntax :CARD:PICKout:STARt
:CARD:PICKout:STARt
{<NRf>}
<NRf> = 1 to 2147483647