YOKOGAWA CW120 - Common Group

App 2-19
IM CW120-E
Communication Commands
App
Appendix 2. Communication Commands
:CARD:SEND?
Function Transfers the contents of the file
that was specified using the
:CARD:FILEname and
:CARD:TYPE commands.
Syntax :CARD:SEND?
→ STX (ASCII-code “02H”), file
contents, ETX (ASCII-code “03H”),
<RMT>
The STX and ETX are not attached
in RS-485 communication.
:CARD:SETTing
Function Creates a setting file in the PC card
and saves the current settings to it.
Syntax :CARD:SETTing {<NRf>}
<NRf> = 0 to 29 (file number)
:CARD:STATe
Function Queries the PC card status.
Syntax :CARD:STATe?
:CARD:STATe {<NRf>}
<NRf> = 0: A card is not set.
1: A card is set.
:CARD:TYPE
Function Sets/queries which type of files in
the PC card is to be accessed.
Syntax :CARD:TYPE
:CARD:TYPE {<NRf>}
<NRf> = 1: Auto-storing file
3: File containing currently
measured values
4: Setting file
1.7.8 Common Group
*CLS (ClearStatus)
Function Clears the error queue.
Syntax *CLS
*IDN? (IDeNtify)
Function Queries the meter model.
Syntax *IDN?
Description A reply sequence is returned as
follows:
<Manufacturer>, <Model>, <Serial
No.>, <Firmware version>.
<Serial No.> is not returned in
actual applications (always 0).