8-6
IM CW120-E
Header (measurement conditions)
CW12x: Indicates the model.
File Type: “2” indicates a file containing instantaneous values
measured.
Measure Mode: “1” indicates electric energy measurement.
Fields of each data record
OUTPUT DATE: Date of output
OUTPUT TIME: Time of output
INTEG START DATE: Integration start date
INTEG START TIME: Integration start time
ELAPSED TIME: Elapsed time of integration
(The order of measured value fields below shows an example for the
single-phase two-wire method.)
V1: Rms voltage (value appearing with “V1” on meter screen)
I1: Rms current (value appearing with “A1” on meter screen)
P: Active power (value appearing with “W” on meter screen)
Q: Reactive power (value appearing with “Var” on meter screen)
PF: Power factor (value appearing with “PF” on meter screen)
F: Frequency (value appearing with “Hz” on meter screen)
Wh(+): Active electric energy (value appearing with “Wh” on meter
screen)
Wh(–): Regenerative energy (not appearing on meter screen)
SEE ALSO
For details, see Appendix 3, “File Structures and Data Items Printed.”
8.3 Saving Data
To Next Page
Loading...
