YOKOGAWA Daqstation DX2010 User Manual

11-15
IM 04L42B01-01E
Troubleshooting
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
CommunicationErrors
For information regarding the communication function of the DX, see the Communication
Interface User’s Manual, IM 04L41B01-17E.
• ErrorsduringSettingandBasicSettingModes,OutputCommunication
CommandExecution,andSetupDataLoading
Code Message
300 Command is too long.
301 Too many number of commands delimited with ‘;’.
302 This command has not been defined.
303 Data request command can not be enumerated with sub-delimiter.
350 Command is not permitted to the current user level.
351 This command cannot be specified in the current mode.
352 The option is not installed.
353 This command cannot be specified in the current setting.
354 This command is not available during sampling or calculating.
• MemoryAccessErrorsduringSettingandBasicSettingModesandOutput
CommunicationCommandExecution
An English error message is returned via the communication interface. It is not displayed
on the screen.
Code Message
362 There are no data to send ‘NEXT’ or ‘RESEND’.
363 All data have already been transferred.
• MaintenanceandTestCommunicationCommandErrors
An English error message is returned via the communication interface. It is not displayed
on the screen.
Code Message
390 Command error.
391 Delimiter error.
392 Parameter error.
393 No permission.
394 No such connection.
395 Use ‘quit’ to close this connection.
396 Failed to disconnect.
397 No TCP control block.
398 Format error.
11.1AListofMessages

YOKOGAWA Daqstation DX2010 Specifications

General

Brand	YOKOGAWA
Model	Daqstation DX2010
Category	Recording Equipment
Language	English