YOKOGAWA DL350 - Sstart Group (Scope Mode Only)

4-145
IM DL350-17EN
Commands
1
2
3
4
5
App
Index
4.27 SSTart Group (Scope mode only)
The commands in this group deal with executing the single start operation. These commands set the trigger mode to
Single and start waveform acquisition.
:SSTart
Function Executes the single start operation.
Syntax
:SSTart
Example
:SSTART
Description When SD recording is enabled, this command
cannot be used.
:SSTart? {<NRf>}
Function Executes the single start operation and waits for
its completion with a timeout period.
Syntax
:SSTart? {<NRf>}
<NRf> = 1 to 36000 (timeout period in 100 ms steps;
start and wait)
<NRf> = –36000 to 1 (timeout period in 100 ms
steps; wait without starting)
Example
:SSTart? 100
Description When SD recording is enabled, this command
cannot be used.