YOKOGAWA DPharp EJX***A Series - Page 83

<5. Parameter Summary>
5-5
IM 01C25T01-06EN
Function Label Item Contents Default value Handling *
1
Event
Notication
4-20mA
Event Notication
Control
HART 7
Event Notication (Enable event notication on
token-passing data link layer,
O󰀨)
O󰀨 W
Device Status
Mask
HART 7
Event Masking W
Status group 1 to
10 Mask
HART 7
Ext dev status
Mask
HART 7
Device Diagnostic
Status 0 Mask
HART 7
Device Diagnostic
Status 1 Mask
HART 7
AO saturated Mask
HART 7
AO xed Mask
HART 7
Set Event
Notication Timing
HART 7
Congure Event Notication Timing Congure Event Notication
Retry Time, Event Max
Update Time and Event
Debounce Interval
M
*1: Handling:
R
=Read only,
W
=Read & Write,
M
=Method,
A
=Applicable for option code AL,
G
=Applicable for option code DG6,
D
=Applicable for di󰀨erential pressure transmitters. Do not change these parameters for pressure transmitters.
*2: Max three Burst Messages (Burst Message 1, Burst Message 2, Burst Message 3)
*3: The default value shows MWP (Maximum working pressure) of the capsule.
Since the working pressure limit varies according to the Model, refer to the General Specications section in each user’s manual.
*4: For output signal code J, refer to the section 3.3.18.
*5: These parameters may contain adjustment values based on the customer range calibration at the factory upon shipment.
When executing “Clear P sensor trim”, P LTD and P UTD will become “0”, and P LTP and P UTP will become the value of LRV and
URV respectively.