YOKOGAWA EML500 Series - 6.6 GPS Interface Setting

6-16
IM80B80T10E 21th Edition : Jul.1,2007-00
< 6.INSTALLATION >
6.6 GPS Interface Setting
If the GPS is connected to back up the EML500, the communication format of the EML500 must
agree with that of the GPS. Set the following items in accordance with the GPS to enable the inter-
face between them:
Header: up to 6 characters
Speed data position: number of commas (i.e., the speed data are
placed after a specied number of commas)
Checksum data : used / not used
Terminator : CR,LF/C0h
Baud rate : 9600/4800/2400
Stop bits : 1 / 1.5 / 2
Parity : Odd / Even / None
Character length : 7 / 8
The setting procedure is shown in the gures on
the following pages.
At -5-A5, press the
F 1
key to select the
GPS interface setting. The display then changes
to that marked a.
Pressing the
PREV
key at a allows the display to
return to -5-A5. If the
F 1
key is pressed
while the display is at a, the format setting mode is
selected. If the
F 2
key is pressed instead, the
protocol setting mode is selected and the display
advances to n (See page 6-17).
The asterisks "******" in the gure indicate the cur-
rent header data. Each time the
F 1
key
(ALPH) is pressed, A to Z , ($), A. (C0h), Z. (0Dh,
0Ah = CR, LF), and a blank space appear one after
the other in the space highlighted in reverse video
(see the display marked c).
If the
F 2
key (NXT) is pressed while the display
is at b, the position of the inverse video highlight
moves right one space (see the display marked d).
Enter a header, conrm it, and then press the
ENT
key. The display changes to that marked f.
While the display is at f, set the number of commas
(,) that are placed before the speed data. The set-
ting range is from 1 to 99 .
Enter a value using the numeric keypad, and then
press the
ENT
key. The display then changes to
that marked h.
F 1 F 2
DISPL
PREV
MODE
F 1 F 2
DISPL
PREV MODE
MAINT
MAINT
F 1 F 2
DISPL
PREV
MODE
MAINT
a.

-5-A5

-5-A51
b.
F 1 F 2
DISPL
PREV
MODE
MAINT
e.
c. d.
F 1 F 2
DISPL
PREV
MODE
MAINT
f.
F 1 F 2
DISPL
PREV
MODE
MAINT
g.
ENT
ENT
Header
setting

-5-A1(Page 6-25)
To n. (page 6-17)
To h.
From h or k
Entry form the
numeric keypad
F 1 F 2
DISPL
PREV
MODE
F 1 F 2
DISPL
PREV MODE
MAINT
MAINT
F 1 F 2
DISPL
PREV
MODE
MAINT
a.

-5-A5

-5-A51
b.
F 1 F 2
DISPL
PREV
MODE
MAINT
e.
c. d.
F 1 F 2
DISPL
PREV
MODE
MAINT
f.
F 1 F 2
DISPL
PREV
MODE
MAINT
g.
ENT
ENT
Header
setting

-5-A1(Page 6-25)
To n. (page 6-17)
To h.
From h or k
Entry form the
numeric keypad