YOKOGAWA FG420 - Page 116

102
IM FG410-01EN
4. BASIC OPERATION
Setting with [Center] (center phase) and [Span] (span phase) instead of the start phase and stop phase
is also possible.

p.90
When the sweep mode is single-shot or gated single-shot, [Trig] (trigger condition) must be set.

p.94
Set the following items as needed.
• Marker phase [Marker] (2nd page of setting screen)

p.96
• Stop level [StpLvl] (3rd page of setting screen)

p.93
This setting can be used only for gated single-shot sweep.
• External control with multi-I/O connector [ExtCtrl] (3rd page of setting screen)

p.98
• Oscillation stop unit for gated single-shot sweep [OscStop] (3rd page of setting screen)

p.93
This setting can be used only for gated single sweep.
• Sync output [SyncOut] (3rd page of setting screen)

p.96