YOKOGAWA FG420 - Setting Amplitude Sweep

103
IM FG410-01EN
4.8.6 Settingamplitudesweep
For the manipulation methods that are common with the sweep setting screen, refer to p.87 and
p.90 .
a) Amplitudesweepexample
The following is an example of continuous, linear shuttle sweep.
Shuttlesweep
Sweep value
Output signal
Start value
Stop value
Sweep time Sweep time
b) Selectingamplitudesweep
When [Mode] (oscillation mode) is set
to [Sweep] (sweep), set [Type] (sweep
type) on the 2nd page of the setting
screen to [Amptd] (amplitude).
c) Waveformsforwhichamplitudesweepisnotpossible
Amplitude sweep is not possible for DC.
d) Settingitemsrequiredforamplitudesweep
Set the following items on the 2nd page of the setting screen. The amplitude settings on the 1st page
of the setting screen are disabled.
• Start amplitude [Start]
• Stop amplitude [Stop]
• Sweep time [Time]
This is the transition time from the start amplitude to the stop amplitude.

p.91
• Sweep mode [SwpMode]
Continuous, single-shot, and gated single-shot can be chosen from.

p.91
• Sweep function [SwpFctn]
One-way/shuttle can be chosen from.

p.90
Setting with [Center] (center amplitude) and [Span] (span amplitude) instead of the start amplitude
and stop amplitude is also possible.

p.90
When the sweep mode is single-shot or gated single-shot, [Trig] (trigger condition) must be set.

p.94
Select [Amptd] in
[Type] and then
press the ENTER
key.
4.8 Sweep Setting and Manipulation