YOKOGAWA FG420 - Auto Burst

To Next Page

To Previous Page

110

IM FG410-01EN

4. BASIC OPERATION

4.9.2 Auto burst

Oscillation and stop are automatically repeated with the respectively specified wave number. No

trigger signal is required.

Settings and manipulations are done on the Oscillator setting screen. “Oscillator” is displayed at the

top left of the Oscillator setting screen. When another screen is displayed, pressing the

key displays the top menu, so select [Oscillator] and then press the

ENTER

ENTER key.

a) Autoburstexample

The following example is for mark wave number (oscillation wave number) = 3, space wave number

(oscillation stop wave number) = 2, oscillation start/stop phase = 30°, stop level = off.

Oscillation start/stop phase

30°

Oscillation phase continues even during stop

Mark wave

number: 3

Space wave

number: 2

Oscillation Stop

b) Settingtheoscillationmodetoautoburst

Set [Mode] (oscillation mode) to [Burst]

on the Oscillator setting screen. The

oscilla-tion mode is switched to the

burst oscillation mode as a result.

In the burst oscillation mode, the

setting screen consists of two pages,

which can be toggled with the

NEXT key.

Next, set [BrstMode] (burst mode) to

[Auto] (auto) on the 2nd page of the

burst oscillation mode.

Select [Burst] in

[Mode] and then

press the ENTER

key.

Select [Auto] in

[BrstMode] and

then press the

ENTER key.