YOKOGAWA FG420 - PANELS AND I;O TERMINALS; Panel Components and Operations

10
IM FG410-01JA
3. PANELSANDI/OTERMINALS
3.1 PanelComponentsandOperations
This section describes the names and functions of the various components on the front and rear
panels.
3.1.1 Front panel of FG410
図
Numeric keypad
Used for numerical input
 p. 35
Basic parameter
shortcut keys
Press to allow the waveform,
frequency, amplitude, and DC
offset to be changed
 p. 38
MENU key
Displays the top menu
 p. 33
LCD panel
Power switch
 p. 25
Soft keys
The manipulation
parameter is displayed on
the LCD panel.
 p. 30
NEXT key
Press to switch setting
screen pages.
 p. 30
CANCEL key
Press to cancel.
 p. 39
ENTER key
Press to enter a setting.
 p. 39
UNDO key
Press to undo setting changes.
 p. 39
Arrow keys
Press to select items, or increase/
decrease values.
 p. 34
Modify knob
Press to select items, or increase/
decrease values.
 p. 34
Manual trigger key
Used for sweep, burst trigger.
 p. 94, p. 115, p. 119, p. 124
Triggered lamp
Lights when a trigger is accepted.
 p. 94, p. 115, p. 119, p. 124
External trigger input terminal  p. 17
External modulation/addition input terminal
 p. 16
Sync/sub-output terminal  p. 15
Waveform output on/off key
Press to switch waveform output on/off.
When on, the lamp on the left is lit.
 p. 45
Waveform output terminal  p. 15
Figure 3-1. Front Panel of FG410