YOKOGAWA FG420 - Front Panel of FG420; Figure 3-3. Front Panel of FG420

12
IM FG410-01JA
3. PANELS AND I/O TERMINALS
3.1.3 Front panel of FG420
Numeric keypad
Used for numerical input
 p. 35
Basic parameter
shortcut keys
Press to allow the waveform,
frequency, amplitude, and DC
offset to be changed
 p. 38
MENU key
Displays the top menu
 p. 33
LCD panel
Power switch
 p. 25
Soft keys
The manipulation
parameter is displayed on
the LCD panel.
 p. 30
NEXT key
Press to switch setting
screen pages.
 p. 30
CH1/CH2 switching key
Press to switch the channel
to be set on the LCD panel.
 p. 42
CANCEL key
Press to cancel.
 p. 39
ENTER key
Press to enter a setting.
 p. 39
UNDO key
Press to undo setting changes.
 p. 39
Arrow keys
Press to select items, or increase/
decrease values.
 p. 34
Modify knob
Press to select items, or increase/
decrease values.
 p. 34
Manual trigger key
Used for sweep, burst trigger.
 p. 94, p. 115, p. 119, p. 124
Triggered lamp
Lights when a trigger is accepted.
 p. 94, p. 115, p. 119, p. 124
CH2 sync/sub-output terminal
 p. 15
CH2 waveform output on/off key
Press to switch CH2 waveform output on/off.
When off, the lamp on the left is lit.
 p. 45
CH2 waveform output terminal
 p. 15
CH1 sync/sub-output terminal
 p. 15
CH1 waveform output on/off key
Press to switch CH1 waveform output on/off.
When on, the lamp on the left is lit.
 p. 45
CH1 waveform output terminal
 p. 15
Figure 3-3. Front Panel of FG420