YOKOGAWA FG420 - Page 42

28
IM FG410-01EN
4. BASIC OPERATION
b) Restorationofsettingsduringpowersupplyon/off
This applies to switching the power supply on/off at one time for this equipment and other embedded
devices when this equipment is mounted in a rack.
When the power supply is cut off while the equipment power is on, the equipment power
automatically goes on the next time the power supply is reconnected.
設定
AAA
設定
BBB
設定
MMM
1
2
1
設定
MMM
2
LINE
LINE
LINE
LINE
LINE
LINE
Power supply connected Power supply disconnected
Power on state
The power is switched off
Power supply connectedPower supply reconnected
Power supply reconnected
Power on state
The power is switched on.
(The settings are set to thecontents
of setting memory 1.)
Setting change
procedure
Power supply disconnected
The power is switched on.
(The settings are set to thecontents
of setting memory 1.)
The power is switched off
• The settings before the power is switched off cannot be restored.
• The contents of setting memory number 1 are set.

p.126
• The output on/off settings at power-on can be set on the Utility screen.

p.45
Check
Since the settings before the power supply is cut off are not restored, specify the
contents of setting memory number 1 beforehand if required.  p. 126