YOKOGAWA FG420 - Restoring the Initial Settings; Output On;Off

45
IM FG410-01EN
4.3.8 Restoring the initial settings
The initial settings can be restored from the Utility screen.
The initial settings that are restored consist of continuous oscillation, sine wave, 1 kHz, 0.1 Vp-p/
open, and output off.
For a list of the initial settings,

p.130 .
1.
Press the
MENU
MENU key to display
the top menu window. In that window,
select [Utility] and then press the
ENTER
ENTER key to display the Utility
screen.
2.
On the Utility screen, select the [Reset]
field and then press the
ENTER
ENTER
key.
The settings are initialized.
4.3.9 Output on/off
a) Manipulationmethodonpanel
Each time the waveform output on/off key is pressed, the
waveform output is switched on/off. When the output is on, the
lamp located to the left of the key lights.
OUT OUT
OUT
Output off
Output on
When the output is off, the output terminal is open. When the output is on, the output impedance is 50
Ω. Sync/sub output is always on regardless of the on/off setting of the waveform output.
b) Settingatpower-on
The waveform output on/off status at power-on can be specified.
The output setting at power-on can be selected from the following three.
• Off [Off]
The output is off.
• On [On]
The output is on.
In the top
menu, select
[Utility] and
then press the
ENTER key.
On the Utility
screen, select
[Reset] and
then press the
ENTER key.
OUT
CH 1
FCTN OUT SYNC/SUB OUT
42V
p
k
Output on/off key
4.3 Basic Settings and Operations