70
IM FG410-01EN
4. BASIC OPERATION
To return the variable parameter values to their initial value, press the [Reset] soft key.
The change is instantly reflected to the output waveform, and the shape of the set
waveform is displayed in graph form.
For details on the variable parameters,
“1. DETAILS OF PARAMETER-VARIABLE
WAVEFORMS” in the Application Instruction Manual.
3.
To apply the changes and quit the selection screen, press the [OK] soft key.
To discard the changes and quit the selection screen, press the [Cancel] soft key.
The changes can also be applied and the selection screen exited by pressing a basic
parameter shortcut key.
Check
The waveform may disappear according to the parameter settings.
If you do not know how to restore the waveform display, press the [Reset] soft key.
This will return each parameter value to the factory default. The polarity and
amplitude range remain unchanged.
To Next Page
Loading...