7-29
IM 04P01B01-01E
Setup Operations for Changing/Adding Functions (Basic Setting Mode)
7
Explanation
Remote No.
The remote control terminal numbers are from 1 to 5.
Function to Be Assigned
Record On/Off: Starts/stops recording.
Alarm ACK: Executes alarm output release.
Time adjust: Adjusts the internal clock to the nearest hour.
Manual print: Executes manual printout.
Message #: Prints message # (where # is a value between 1 and 5).
Chart speed: Changes the chart speed.
Math start/stop: Starts/stops the computation on the computation function (/M1
option).
Math reset: Resets the computed result of the computation function (/M1 option).
Priority R_RCD: Starts/stops recording (/BT1 option).
BatchCMT switch: Start printout and Start printout 2, End printout and End printout 2
switches according to the status of the “BatchCMT switch” signal
during the rising or falling of the “Record On/Off” or “Priority R_RCD”
signal (/BT1 option).
Data save On/Off: Starts/stops data saving to the SD memory card (/EM1 option).
None: No function is assigned.
Note
When you select “Priority R_RCD” and start recording remotely, you cannot stop recording
using key operation or communications.
<Related Topics> Setting the secondary chart speed: Section 6.9
7.18 Assigning Functions to the Remote Control Input Terminals (/R1 Option)
To Next Page
Loading...
