YOKOGAWA PT500 - Chapter 26 Boundary of speed status output

26-1
SM80B22M02E
Chapter 26 Boundary of speed status output
This speed status output is used for changing over the max. rudder angle automatically. For example
Max. rudder angle 35deg. to 70deg.
Boundary control function can change around the boundary line smoothly by adding hysteresis
Setting item is as follows.
①Select Enable or Disable of the speed status output
②Set the threshold of low speed boundary
③Set the threshold of high speed boundary
１． Change the item
（１）Press the ENTER
ENTERENTER
ENTER key after displayed "
Option Set 5… "(PT500A) or " Option Set 6… "
(PT500D・SUBAUTO) on the data display.
Data display becomes setting mode of speed status output.
（２）Change the setting mode by using the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- Key
①⇔②⇔③⇔④⇔①
①
③
②
④
Press ENTER
ENTERENTER
ENTER key to select the setting item.
Speed Status
…
Function= aaaaaaa
Speed Status
…
Low Speed= ##kt
Speed Status
…
High Speed= ##kt
Speed Status
…
<EXIT>
＜Enable the hysteresis＞
There are two boundary line for low speed and high speed band
＜Disable the hysteresis＞
It use the same boundary line for low speed and high speed band
Maintenance 1
7
:
Option
setting