YOKOGAWA PT500 - 2. Select Enable or Disable of the speed status output; 3. Set the threshold of low speed boundary

26-2
SM80B2M22E
２． Select Enable or Disable of the speed status output
（１）Press the ENTER
ENTERENTER
ENTER key after displayed "
Function＝ " on the data display.
Data display become current setting mode.
a....a means setting item
Enable ：Valid
Disable ：Invalid
（２）Press △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to alter the item “
Enable” ⇔
⇔⇔
⇔ ”
””
” Disable ”
””
”
Press ENTER
ENTERENTER
ENTER key to set the Enable or Disable.
(NOTE)
Speed status output driver is used to the same OFF HEADING status output driver.
If you selected the‘Enable’,OFF HEADING status output is prohibited by software.
It is not possible to output the both Speed status and OFF HEADING status.
３．Set the threshold of low speed boundary
（１）Select the " Low Speed＝ ##kt " mode on the data display. Then press ENTER
ENTERENTER
ENTER key.
The data display become under setting mode.
Setting range 3 to 40
(Initial value is set 10 knots)
（２）Press △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to alter the speed value.
Press ENTER
ENTERENTER
ENTER key after setting the low speed boundary.
４．Set the threshold of high speed boundary
（１）Select the "
High Speed＝ ##kt " mode on the data display. Then press ENTER
ENTERENTER
ENTER key.
The data display become under setting mode.
Setting range 10 to 40
(Initial value is set 10 knots)
（２）Press △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to alter the speed value.
Press ENTER
ENTERENTER
ENTER key after setting the high speed boundary.
Speed Status
…
Function= aaaaaaa
Speed Status
…
Low Speed= ##kt
Speed Status
…
High Speed= ##kt