27-1
SM80B22M02E
Chapter 27 Special flag setting
These settings are used for adjustment of Track Control or Special function.
Setting item is as follows.
【In case of PT500A】
① Option flag-0 (for Track control)
② Option flag-1 (for DNV application)
③ Derivative gain multiplier setting for Track Control
④ Integral gain multiplier setting for Track Control
⑤ Integral gain multiplier setting during the course keeping control(AUTO)
⑥ The multiplier of turn rate to output initial rudder order for starting turn.
⑦ Rate down check setting (Setting of timing for reducing rate of turn in the turning)
⑧ Pilot operation mode
⑨ Option data-0
⑩ Option data-1
⑪ Option data-2
⑫ Option data-3
⑬ Option data-4
⑭ Option data-5
１． Change the item
Press the
ENTER
ENTERENTER
ENTER
key after displayed "
MAINTENACE 18
…
"(PT500A) on the data display.
Data display becomes setting mode of [Flag-0(Hex)].
（１） Change the setting mode by using the
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
Key.
①⇔②⇔③⇔④⇔⑤⇔⑥⇔⑦⇔⑧⇔⑨⇔⑩⇔⑪⇔⑫⇔⑬⇔①
①
To Next Page
Loading...