27-10
SM80B22M02E
１０． Pilot operation mode
The display method of set course during Manual mode can be set in this setting.
Setting value:
Mode(Hex)=[00]：The value of set course display is changeable by the course setting devices
(Course setting dial or Course setting keys) during the manual steering mode.
⇒This setting is used for "the stand alone type Autopilot" or when Auto
steering unit is located in close of Hand steering unit.
Mode(Hex)=[02]：The present heading value is indicated in the set course display during manual
steering mode.
⇒This setting is used when the Autopilot is separated from Hand steering
unit, like IBS layout.
Setting range : 0 to 9
Initial value : [00]
NOTE)
Autopilot read in the actual heading as preset heading during HAND mode and when the
steering mode is switched from manual to automatic steering mode, and then starts Heading
control.
In previous software, the indication of preset heading has been blinked for 20 seconds after
changing from manual to automatic steering and if the ENTER key was pressed within 20
seconds, the blinking value has been used as the preset heading.
However, above function was removed because the user operation should be made more
easily and the display of the preset heading should be made more clearly.
（１）Press the
ENTER
ENTERENTER
ENTER
key after displayed "
Mode(Hex)=##
" on the data display.
Data display becomes current setting mode.
←Cursor position is inputting point
（２） Press
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
key to set the cursor point. Then change the data by turning the Set
course dial. Turn to the clockwise direction, data is increased and turn to the counter clockwise
direction, data is decreased. (Data is 0 to 9 numbers)
（３）After input the flag, then press
ENTER
ENTERENTER
ENTER
key.
=0: Normal mode
=1: Exibision mode
=0:
When Auto steering unit is located in close of Hand
steering unit.
The set-course display is kept the last value in
To Next Page
Loading...