YOKOGAWA PT500 - ２．３ Hardware Setting of the INS;GPS

2-12
SM80B22M02E
２．３ Hardware setting of the INS/GPS
Set the protocol of the INS/GPS. Setting item is as follows.
①Baud rate
②Length of the character
③Parity check
④Length of the stop bit
（１）Set the mode.
Then press ENTER
ENTERENTER
ENTER key.
Data display becomes a Hardware setting ready mode for INS/GPS protocol port.
（２）Change the setting mode by using the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- Keys.
①⇔②⇔③⇔④⇔⑤⇔⑥⇔①
①
Baud rate
②
Length of the character
③
Parity check
④
Length of stop bit
⑤
Back to the previous mode.
⑥
Back to the I/F setup top menu mode.
Press the ENTER
ENTERENTER
ENTER key after you selected the setting mode. It become the each protocol setting mode .
Following setting item is the same as Gyrocompass hardware setting
Refer to Gyrocompass hardware setting.
MAINTENANCE 1
…
I/F SET-UP
I/F SET
-
UP
…
HARDWARE SET
I/F HARD SET
-
UP
…
PORT= INS/GPS
INS/GPS HARD
…
BAUD RATE = ####
INS/GPS HARD
…
DATA BITS = #
INS/GPS HARD
…
PARITY = aaaa
INS/GPS HARD
…
STOP BITS = #
INS/GPS HARD
…
[PREV]
INS/GPS HARD
…
[TOP]