YOKOGAWA PT500 - 3. Software setting

2-14
SM80B22M02E
３． Software setting
Set the protocol for Gyro compass input and Auxiliary compass input , INS/GPS input and output.
Setting item is as follows.
① Software setting of the Gyrocompass input
② Software setting of the Auxiliary compass input
③ Software setting of the INS/GPS input
④ Software setting of the INS/GPS output
⑤ Software setting of the LOG input
（１）Set the key.
Then press ENTER
ENTERENTER
ENTER key.
Data display become a Hardware setting ready mode for each inputting port.
（２）Change the setting mode by using the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- Keys.
①⇔②⇔③⇔④⇔⑤⇔⑥⇔⑦⇔①
①
Set the Input signal of the Gyrocompass data
②
Set the Input signal of the Auxiliary compass data
③
Set the Input signal of the INS/GPS data
④
Set the output signal of the INS/GPS data
⑤
Set the Input signal of the LOG data
⑥
Back to the previous mode.
⑦
Back to the I/F setup top menu mode.
Press the ENTER
ENTERENTER
ENTER key after you selected the setting mode. It become the each protocol setting mode .
MAINTENANCE
1
…
I/F SET-UP
I/F SET
-
UP
…
SOFTWARE SET
I/F SOFT SET
-
UP
…
PORT= GYRO
I/F SOFT SET
-
UP
…
PORT= AUX.COMP
I/F SOFT SET
-
UP
…
PORT=INS/GPS INP
I/F SOFT SET
-
UP
…
PORT=INS/GPS OUT
I/F SOFT SET
-
UP
…
[PREV]
I/F SOFT SET
-
UP
…
[TOP]
I/F SOFT SET
-
UP
…
PORT=LOG INP