YOKOGAWA PT500 - Set the Data Field Position of the Reception Data; Setting of the Data Field Position

2-20
SM80B22M02E
3.1.2.3 Setting of the data field position
Set the data field position of the reception data
Example）
”＄ＡＢＣＤＥ，１２３．３，４５６．７，８９０．１，２３４．５＊”
In case of set the data field at“3”above text data ,reception data become “890.1”.
（１）When you displayed the "
START POS.= ## " on the data display, press ENTER
ENTERENTER
ENTER key.
The data display become under setting mode.
（２）Press the △
△△
△ +
++
+ or ▽
▽▽
▽ -
--
- key to select the setting mode. Then press ENTER
ENTERENTER
ENTER key.
ADJ
UST
ENTER
ENTER
ENTER
ADJUST
ENTER
ENTER
ENTER
ENTER
GYRO NEW
START POS.< 1
ADJUST MODE
99…
MAINTENANCE MODE
MAINTENANCE 1
…
I/F SET-UP
ADJUST MODE
1
…
DIMMER/CONTRAST
SPD AUTO 13.5 Kt
HEADING-G 235.8ˆ
GYRO NEW
…
ADDRESS = $aaaaa
GYRO SOFT
…
FORMAT = NEW
I/F SOFT SET
-
UP
…
PORT = GYRO
I/F SET
-
UP
…
SOFTWARE SET
I/F SET
-
UP
…
HARDWARE SET
GYRO NEW
…
START POS.= ##
GYRO NEW
START POS.< 1
GYRO NEW
START POS.< 2
GYRO NEW
START POS.< 3
GYRO NEW
START POS.< 98
GYRO NEW
START POS.< 99