11-
3
SM80B22M02E
１．２
Input the Length between perpendiculars
（ＬＰＰ）
Refer to fig.1 for LPP
（１）
When you are displayed
"
LPP= ###.##
" on the data display ,then press
ENTER
ENTERENTER
ENTER
key.
The data display become under setting mode.
←
Cursor position is inputting point
（２）
Press
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
key to set the cursor point. Then change the data by turning the Set
course dial. Turn to the clockwise direction , data is increased and turn to the counter
clockwise direction ,data is decreased. (Data is 0 to 9 Numerical value)
（３）
After input the LPP data , then press
ENTER
ENTERENTER
ENTER
key.
１．３
Input the Molded breadth
（Ｂ－ｍｌｄ）
Refer to fig.1 for B-mld.
（１）
When you are displayed "
B-mld= ##.##
" on the data display ,then press
ENTER
ENTERENTER
ENTER
key.
The data display become under setting mode.
←
Cursor position is inputting point
（２）
Press
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
key to set the cursor point. Then change the data by turning the Set
course dial. Turn to the clockwise direction , data is increased and turn to the counter
clockwise direction ,data is decreased. (Data is 0 to 9 Numerical value)
（３）
After input the B-mld data , then press
ENTER
ENTERENTER
ENTER
key.
To Next Page
Loading...