11-4
SM80B22M02E
１．４
Input the Designed full load draft (D-Full load)
Refer to fig2. for D-Full load
（１）
When you are displayed "
D-Full= ##.##
"on the data display ,then press
ENTER
ENTERENTER
ENTER
key.
The data display become under setting mode.
←
Cursor position is inputting point
（２）
Press
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
key to set the cursor point. Then change the data by turning the Set
course dial. Turn to the clockwise direction , data is increased and turn to the counter
clockwise direction ,data is decreased. (Data is 0 to 9 Numerical value)
（３）
After input the D-Full data , then press
ENTER
ENTERENTER
ENTER
key.
１．５
Input the Designed full load displacement (Full load displacement)
（
Full Disp.
）
（１）
When you are displayed "
Full Disp=######
" on the data display ,then press
ENTER
ENTERENTER
ENTER
key.
The data display become under setting mode.
←
Cursor position is inputting point
（２）
Press
△
△△
△
+
++
+
or
▽
▽▽
▽
-
--
-
key to set the cursor point. Then change the data by turning the Set
course dial. Turn to the clockwise direction , data is increased and turn to the counter
clockwise direction ,data is decreased. (Data is 0 to 9 Numerical value)
（３）
After input the Full Disp data , then press
ENTER
ENTERENTER
ENTER
key.
To Next Page
Loading...