YOKOGAWA SC72 - Page 29

IM 12D03D02-01E
4-2
4. Keypad and Display Functions
DATA
: DATA key
When pressed during measurement, mark ash and the currently displayed
measured conductivity value and temperature are held temporarily. Pressing
F/ENT
key while mark is ashing, will store the held data in memory. After the data is
stored successfully, the meter returns to measurement mode automatically. To cancel
data storage, press
DATA
or
MEAS
key while mark is ashing.
mark will turn o󰀨 and the meter will return to measurement mode.
MEAS
: Measurement key
In measurement mode each press of this key cycles through three measurement
display panels (refer to Section 3.2, “Measurement Procedures”). Pressing this key
in other modes will return the meter to measurement mode. If you want to cancel any
operation, press this key to return to measurement mode.
: Setting change keys
Used to change settings.
F/ENT
: Entry key
Pressing this key during measurement moves the display to function mode (refer to
Section 4.3, “Function Modes”). This key is also used to conrm data entry.
Beep sound
When a key is pressed, the meter acknowledges it using a beep sound.
(1) One beep
The meter will beep once conrming a valid key entry.
(2) Three beeps
The meter will beep three times if the key entry is invalid.
To disable the beep, refer to Section 4.3 (11), “Set beep on/o󰀨 (bZ.o) panel.” Note that
the volume of the beep sound is not adjustable.