YOKOGAWA UT55A - Page 311

12-14
IM 05P01C31-01EN
Key and Display Status
The key and display status can be output to the contact output. (The setpoints below are
I relay numbers.)
Setpoint Function
Contact status
ON OFF
4705 PARAMETER key
Key is pressed Key is not pressed
4706 DISPLAY key
4707 Right arrow key
4708 Down arrow key
4709 SET/ENTER key
4710 Up arrow key
4711 Left key
4712 F2 key
4713 F1 key
4714 A/M key
4715 Fn key
OperationModeandStatus
Setpoint Function
Contact status
ON OFF
4193 AUTO/MAN MAN AUTO
4194 Remote/Local Remote Local
4226 Remote/Local (Loop 2) Remote Local
4195 STOP/RUN STOP RUN
4197 Cascade (in Cascade control) Cascade(OFF→ON) AUTO or MAN
4198 AUT
O (in Cascade control) AUTO (OFF→ON) Cascade or MAN
4199 MAN (in Cascade control) MAN (OFF→ON) Cascade or AUTO
4201 Output tracking status Tracking ON Tracking OFF
4207 During auto-tuning During AT –
4239 During auto-tuning (Loop 2) During AT –
4209 Duringautomaticvalveadjustment Duringadjustment –
4210
During operartion by the valve position
estimating type
During operation by
estimating type
During operation by
feedback input
4213 V
alveis
open Open –
4214 Valveisclosed Closed –
4256 FAIL output Normal status FAIL status
SystemErrorStatus
Setpoint Function
Contact status
ON OFF
4529 Heater break alarm 1 status Alarm occurs Normal
4530 Heater break alarm 2 status Alarm occurs Normal
4769 Message display interruption 1 status With interruption Without interruption
4770 Message display interruption 2 status With interruption Without interruption
4771 Message display interruption 3 status With interruption Without interruption
4773 Message display interruption 4 status With interruption Without interruption
12.2SettingContactOutputFunction