• Power On:
You can only turn on the power after connecting the cables to the processor module.
• Removing the processor module while the system is running:
Remove the processor module with the cables connected to it.
• Mounting the processor module while the system is running:
You can mount the processor module after connecting the cables to it.
Bus cable
Bus connector
Bus connector
Processor module
Figure 3.3.2-2 Connecting Cables for Vnet/IP
<3.3 Connecting Control Bus Cables > 3-18
IM 32Q06C10-31E 4th Edition : Jan.30,2015-00
To Next Page
Loading...
