YOKOGAWA WT310EH - Displaying Phase Angles and Frequencies

4-5
IM WT310E-01EN
Measuring Power
1
2
3
4
5
6
7
8
App
Index
4.3 Displaying Phase Angles and Frequencies
Procedure
Displayed Function
Press the FUNCTIONkeyfordisplayBorDtoselect°(phaseangle),VHz(voltagefrequency),orA
Hz (current frequency).
Each time you press FUNCTION, the displayed function changes in the order shown below.
VHz AHz
Display
B
D
°
• TheTHDindicatorisontheleftsideofthe7-segmentLEDdisplay.
• PressSHIFTbeforepressingFUNCTIONtochangethedisplayedfunctioninreverseorder.
Input Element (WT332E/WT333E only)
Press the ELEMENTkeyofthedisplaythatyouselectedthedisplayfunctionfor(displayBorD),and
then select an input element.
The procedure for selecting an input element is the same as the procedure in section 4.1.
The WT310E and WT310EH only have one input element, so there is no input element selection.
Explanation
Displayed Function
Select which measurement function to show on the display.
• °:PhaseangleΦisdisplayed.
• VHz:VoltagefrequencyfUisdisplayed.
• AHz:CurrentfrequencyfIisdisplayed.
Maximum Displayed Value, Units, and Unit Prefixes
• Phaseangledisplayrange:G180.0tod180.0(Gisthelaganddisthelead)
• Maximumdisplayedfrequency:99999(whenthenumberofdisplayeddigitsissetto5)
• Units:°forphaseanglesandHzforfrequency
• Unitprefix:mork(onlyforfrequencies)